Dryer Repair in Hamilton

How we fix it

A dryer that runs but stays cold usually has a blown thermal fuse, and that fuse almost always blows because the vent is clogged, so we check the ducting and lint path first rather than swapping the part and watching it fail again. On an electric model we test the heating element and thermostats for continuity; on a gas one we check the igniter and gas valve, which we handle safely since we're certified for gas. A burned-out element or a dead igniter gets replaced rather than bodged, because there's no reliable way to repair one and a fresh part brings the heat back properly. Then we clear the vent, run a heated cycle, and feel the exhaust to confirm it's actually drying.

How we fix it

When the motor hums but the drum sits still, the belt has usually snapped or slipped off, so we take off the front or top panel to see what's going on inside. We check the idler pulley and drum rollers while we're in there, since a seized pulley will chew through a new belt in no time if we leave it. A stretched belt or a worn pulley gets replaced together rather than one on its own, because fitting a fresh belt onto a tired pulley just brings the problem back. Once it's reassembled we run the drum empty and listen for smooth, even rotation before we close up.

How we fix it

A squeal or a rumble nearly always comes from the parts the drum rides on, so we open the cabinet and turn the drum by hand to pin down where the noise starts. We rule out the easy stuff first, like a coin lodged in the drum seam or a loose blower wheel, before pulling the rollers. Worn rollers and a tired idler pulley are replaced as a set, since putting a new roller next to three old ones just shifts the noise along, and the felt seals go back fresh at the same time. After it's back together we run it empty and check it turns quietly before handing it over.

How we fix it

If the dryer is dead or quits partway through, we start at the door switch and the thermal fuse, since either one will cut power the moment it fails and both are quick to test. A dryer that shuts off mid-cycle is often overheating, so we check the vent and the high-limit thermostat to find out why rather than just resetting it. A failed door switch, fuse, or thermostat gets replaced, because these are safety parts that aren't meant to be repaired once they've tripped for good. We finish by running a full cycle and making sure it starts, holds, and finishes without cutting out.